HOW TO SET UP?
The system must recognize your MIDI CD controller/s before configuring in DJ ProMixer.
– Check and install the drivers of your device from the oficial website.
– Your MIDI CD Controller could be only MIDI or MIDI with audio sound card integrated.
Plug your MIDI CD Controller and go to “Config” to configurate it.
Select in MIDI PORT / MIDI MAP 1 on the left side one MIDI CD Controller device and select on the right side the SINGLE A.XML map. Select in MIDI PORT / MIDI MAP 2 on the left side the other MIDI CD Controller device and select on the right side the SINGLE B.XML map
Select in MIDI PORT / MIDI MAP 1 on the left side your MIDI CD Controller device, and select on the right side the (A AND B).XML map. Nothing selected in MIDI PORT / MIDI MAP 2
How to change the decks? Two ways: 1.- Hardware: Check the assigned button at MIDI map. 2.- Software: By clicking the headphone button of the deck.
(If your MIDI CD Controller has audio sound card)
Open DJ ProMixer and go to “Config” open “Audio Setup”, here you can select your MIDI CD Controller as Audio Sound Card.
There are two ways to connect your device/s as Audio Sound Card (It depends of the drivers of the manufacturer):
1.- ASIO Driver Mode (If it is supported)
2.- Direct sound
Normally every device has assigned a physical button to change the deck.
You can change also with headphones button (A / B) or / and and A / B button of the track info.